Acquiring Disk Image with dd and dcfldd

Acquiring Disk Image with dd and dcfldd

When to Use

• When you need to create a forensic copy of a suspect drive for investigation
• During incident response when preserving volatile disk evidence before analysis
• When law enforcement or legal proceedings require a verified bit-for-bit copy
• Before performing any destructive analysis on a storage device
• When acquiring images from physical drives, USB devices, or memory cards

Prerequisites

• Linux-based forensic workstation (SIFT, Kali, or any Linux distro)
• dd (pre-installed on all Linux systems) or dcfldd (enhanced forensic version)
• Write-blocker hardware or software write-blocking configured
• Destination drive with sufficient storage (larger than source)
• Root/sudo privileges on the forensic workstation
• SHA-256 or MD5 hashing utilities (sha256sum, md5sum)

Workflow

Step 1: Identify the Target Device and Enable Write Protection

# List all connected block devices to identify the target
lsblk -o NAME,SIZE,TYPE,MOUNTPOINT,MODEL

# Verify the device details
fdisk -l /dev/sdb

# Enable software write-blocking (if no hardware blocker)
blockdev --setro /dev/sdb

# Verify read-only status
blockdev --getro /dev/sdb
# Output: 1 (means read-only is enabled)

# Alternatively, use udev rules for persistent write-blocking
echo 'SUBSYSTEM=="block", ATTRS{serial}=="WD-WCAV5H861234", ATTR{ro}="1"' > /etc/udev/rules.d/99-writeblock.rules
udevadm control --reload-rules